DIY Sand Sieve Sand Sifter
You can make a sand sifter at home using materials that can be scavenged around your tool shed. The size of the wire mesh to be used as a sieve depends on the size of the materials you want to filter out of the sand. Homemade sieves for sand are generally made out of wood and wire or screen mesh and the assembly requires no expertise on your part. There are a lot of variations in design and materials you can use depending on your DIY skill and the area and amount of sand you want to sift through.
How To Make A Sand Sifter?
Materials required: 1/8″ wire mesh, 8 pieces of wood,( all of the same size), and duct tape Tools required: tape measure, scissors, wire shears, gloves, and a sharpie. First, you have to make two squares with dimensions the same as that of your sieve size. Then you have to fit one square precisely on top of the other one without gaps with glue. Then the positions for each wire are marked mark off a line on all four sides of the bottom wood frame for the wire mesh. Then the wire mesh is fitted into the inside of bottom square and nails are attached at the ends to secure them. Once the wire mesh has been placed and secured, you must glue everything into place. First, the nails securing the wires are glued. Then upper square is glued onto bottom square to complete assembly
Things To Consider Before Collecting Materials
If you are making a large-sized fine-mesh sieve, you will need to provide additional support for the fine wire mesh with heavier wires running diagonally under the mesh.
Tips For Making:
To make a hand sand sifter, you will need: -A square frame -Two pieces of wood (one for the frame and one for the sanding surface) -Duct tape -Wooden or plastic sandpaper (18" x 14") -Paint or wood stain
Variations Of it’s Designs
An advanced design can be used for a sand sifter, with two rectangular frames that have equal width, but one longer than the other. The longer pieces of timber are grooved to function as runners, with the smaller frames have the mesh and caster wheels fixed onto them, which are slid up and down to the larger frame along the grooves, and the whole device is set upon a wheelbarrow for easy collection of sifted materials. You can also melt plastic onto the nails used to secure the mesh instead of wood glue, and use melted plastic to seal the two squares together. This can be used to recycle plastic and increase the strength of the connection. ..
Conclusion
A homemade sand sifter can be a very handy tool for cleaning up your local beach. By using common materials and techniques, you can make a simple and effective tool that is perfect for sifting soil or stones.
Yes, plastic mesh can be used in place of wire mesh to create a more secure fence.
The plastic mesh has a lower tensile strength than wire mesh, so the sieve size will have to be small in order to get the desired results.
Wires from cars can be used to make a mesh. By using a wire connector, you can connect two wires together to create a mesh.
After stripping the insulation off the wires, use a proper frame to wrap the wires onto the squares to make the mesh.
